Hager Roton 780-300-83" HD Continuous Hinge -Center Hung Applications , Half Surface

780-300 HD
10.00 LBS
Calculated at Checkout



Hager Roton 780-300 Continuous Hinge - Heavy Duty, Half Surface Center Hung Applications

Hager Roton continuous geared hinges are designed to provide superior performance you can rely on in high-traffic areas because they use a unique rotating joint, not a pin. This minimizes lateral wear on the hinge while evenly distributing door weight along the full length of the frame. Roton continuous geared hinges are an ideal choice for new construction or retrofit applications.

Door And Frame Preparation - All Roton Continuous Geared Hinges are surface-applied. Cutout design and spacing coordination is thereby eliminated in both new construction and restoration work. Reinforcement plates are not required in doors or frames except where the gauge is too thin for the fasteners in relation to the door weight or where abusive operation is anticipated.

Door Closers - Conventional surface or concealed sliding closers may be used with Roton. (Note: Pivot type floor closers with a fixed, conflicting pivot point may not be used). Closers will last considerably longer, adjust to operating requirements more readily and show consistent settings due to the reduced operating forces of Roton hinging.



Heavy Duty Half Surface Hinge

 Heavy duty for high frequency, center hung

doors or heavy, medium frequency, center

hung doors.

Material: Aluminum 6063-T6

Clearance: 1/32” (1 mm) minimum

recommended between

door and frame

Fasteners: Dril-Kwik® screws

Length Options: • Standard sizes include

79” (2007 mm)

83” (2108 mm)

85” (2159 mm)

95” (2413 mm)

119” (3023 mm)

• Custom lengths



Reinforcement: None required to 200 lbs,



View AllClose